Skip to content
Redmoon Calculators
Schrijftools All languages

Herringbone & Chevron Tile Calculator

Free herringbone and chevron tile calculator. Enter room size, tile dimensions, and layout pattern to get tiles needed, boxes to buy, and total cost — with the correct waste factor for angled cuts already applied.

Wanneer gebruiken

Use before ordering tile for a herringbone or chevron floor or backsplash — the built-in waste factor keeps you from running short mid-job.

Vergelijking

Straight-lay tile calculators underestimate herringbone and chevron jobs by 8–10 points of waste. This one uses the pattern-specific factor.

Enter your values below. Calculations run locally as you type.

Zo werkt het

Room area (sq ft) is divided by each tile's area to get a base tile count, then inflated by a waste factor for angled cuts: 18% for herringbone, 20% for chevron, 10% for a straight lay.

Tiles needed is rounded up to a whole tile, then divided by tiles per box and rounded up again so you never come up short mid-install.

Total cost = boxes needed × cost per box.

Veelgestelde vragen

Why does herringbone waste more tile than a straight lay?

Herringbone and chevron patterns require angled cuts at every wall edge and border, and many of those cut-off pieces are too small to reuse elsewhere. That pushes the waste factor to around 18–20%, versus roughly 10% for a simple straight or running-bond layout.

What's the actual cutting difference between chevron and herringbone?

Herringbone tiles are cut square and interlock at 90-degree offsets, so only the border tiles need angled cuts. Chevron tiles are pre-mitered at an angle so every tile edge meets its neighbor in a continuous V, which needs slightly more precise, and slightly more wasteful, cutting — hence the higher default waste factor.

Should I buy an extra box for future repairs?

Yes. Tile dye lots vary from batch to batch, so a box bought a year later to replace a cracked tile may not match. Buying one extra box now, while everything is from the same run, is cheap insurance against a visible mismatch later.

Voorbeeld

Invoer

10×10 ft room, 3×12 in plank tile, herringbone pattern, 8 tiles/box, $35/box.

Uitvoer

472 tiles, 59 boxes, $2,065.

Area = 10×10 = 100 sq ft. Tile area = (3×12)/144 = 0.25 sq ft. Tiles needed = ceil((100/0.25) × 1.18) = 472. Boxes = ceil(472/8) = 59. Cost = 59 × $35 = $2,065.

Veelgemaakte fouten

  • Waste factors are averages — intricate room shapes with lots of corners may need more.
  • Doesn't subtract for doors or fixtures; measure net floor area first.
  • Always buy the rounded-up box count, even if it looks like more than you need — partial boxes aren't sold at most retailers.

Verwante tools

Feedback sturen

We lezen elk bericht. Vertel ons wat beter kan of wat je leuk vindt.